User Manual Q&AAnswer
Feb 26, 2025 - 08:26 PM
To configure ERPS nimble mode on the FS S3150-8T2FP PoE+ Series Switches, follow these steps:
1. Enter the global configuration mode by typing "Switch_config#" in the command line interface.
2. Configure the switch to ERPS nimble mode by typing "erps nimble-mode" in the command line interface.
3. Exit the global configuration mode by typing "exit" in the command line interface.
Note: The nimble mode is a simplified configuration mode that only requires the configuration of ERPS-related commands. CFM configuration is not required in nimble mode.
Please refer to the FS S3150-8T2FP PoE+ Series Switches Ethernet Ring Protection User Guide for more detailed information on ERPS configuration.
Add New Comment