User Manual Q&AAnswer
Feb 26, 2025 - 08:15 PM
To install the Eureka Aquaguard Smart Plus water purifier, follow these steps:
1. Choose a dry and ventilated location for installation, away from direct sunlight or freezing temperatures.
2. Connect the purifier to a cold tap water source. Do not connect it to hot tap water as it can damage the filters.
3. Ensure that the tap water pressure is between 4.26 psi to 42.6 psi (0.3 to 3.0 kg/cm).
4. If the water pressure in your area is lower than the minimum specified, you may need to use an external booster pump. If the pressure is higher than the maximum specified, a pressure reducing valve (PRV) is recommended.
5. Make sure that the reject water pipe is placed lower than the top of the purifier to prevent water from flowing back into the purifier.
6. Install the purifier within 1.0m distance from the tap water supply.
7. Connect the purifier to a 230V power outlet. It is important to use the correct voltage.
8. Do not install the purifier in a place where water or rain could leak into it, such as outdoors.
Note: The installation process may vary depending on your specific model and local conditions. It is recommended to refer to the user manual for detailed installation instructions and diagrams.
Please ensure that you read the user manual carefully before commencing the installation process to ensure proper installation and usage of the Eureka Aquaguard Smart Plus water purifier.
Add New Comment