How do I install the Riland Cutting Machine? (Riland Cutting Machine User Manual)

Answer

manuals.plus

Feb 26, 2025 - 07:11 AM


To install the Riland LGK-100IJ Cutting Machine, please follow these steps:

1. Make sure the intake of the machine is not blocked or covered to avoid malfunction of the cooling system.
2. Ensure that the earth end of the power interface has been reliably and independently grounded.
3. Use pressure-resisting air pipe to connect the air intake and compressed air source, and tighten the joint with a hoop or other methods to prevent gas leaking. Supply dry gas with suitable pressure and flow. If your air source does not meet these requirements, consider using a separate compressor with enough power and an air-decompressing filter.
4. Install the air-electricity system plug to the relevant socket on the panel and tighten it clockwise. Connect the air plug of the cutting torch and arc-keeping cable to the relevant socket and tighten the joint  xxxx .
5. Connect the cable plug to the socket on the panel and tighten it clockwise. Clamp the workpiece with the earth clamp.
6. According to the input voltage grade, connect the power cable with the power supply box of the relevant voltage grade. Ensure there are no mistakes and that the voltage of the power supply does not exceed the permitted range.
7. Connect the cables following the correct schematic.

Please refer to the user manual for more detailed instructions and diagrams on the installation process.