User Manual Q&AAnswer
Feb 26, 2025 - 06:04 AM
To attach the tilt lock handle to the Timpani² LED light panel, follow these steps:
1. Place the Timpani² and yoke facedown on a flat surface.
2. Use the included hex key to remove one of the tilt control screws located on the yoke.
3. Replace the removed xxxx with the tilt lock handle. xxxx it in so that the threads are engaged, but do not tighten it fully.
4. Use the hex key to tighten the control xxxx on the other side of the yoke. Tighten it enough until there is some resistance while tilting the Timpani² in the yoke.
5. Finally, tighten the handle until the yoke is locked and secure.
Note: If the yoke seems too loose when the tilt lock handle is disengaged, use the hex key to slightly tighten the control xxxx opposite the handle.
Please refer to the user guide for visual illustrations and additional information.
Add New Comment