How do I configure port aggregation on the FS S3150-8T2FP Multi-Port Gigabit Ethernet Switch? (FS S3150-8T2FP Multi-Port Ethernet Switch User Guide)

Answer

manuals.plus

Feb 26, 2025 - 05:58 AM


To configure port aggregation on the FS S3150-8T2FP Multi-Port Gigabit Ethernet Switch, follow these steps:

1. Configure the logical channel used for aggregation:
   - Use the command "interface port-aggregator id" to configure the aggregated logical channel.

2. Choose the aggregation mode (static or LACP):
   - For static aggregation, ensure that the link of the physical port is up and the VLAN attribute of the aggregation port and physical port is identical. The port will be aggregated to the logical channel regardless of the current port's conditions.
   - For LACP aggregation, both the local end and the opposite end must pass the negotiation process. The link of the port must be up, and the port should be negotiated to full-duplex mode. The speed and VLAN attributes of all physical ports must be the same as the aggregated port.

3. Select the load balance mode after port aggregation:
   - The switch supports up to six load balance strategies, including src-mac, dst-mac, and both-mac. These strategies determine how the data traffic is shared among the aggregated physical ports.

4. Monitor the condition of port aggregation:
   - Use the command "show aggregator-group [id] {detail|brief|summary}" to monitor the state of port aggregation. This command will display the port aggregation state.

Please refer to the FS S3150-8T2FP Multi-Port Gigabit Ethernet Switch User Guide for more detailed instructions and examples on configuring port aggregation.