User Manual Q&AAnswer
Feb 26, 2025 - 04:46 AM
Sure! Here is a step-by-step guide on how to install the Skinner EM Emergency Pipe Repair Clamp:
Step 1: Thoroughly clean the damaged area with a wire brush. Remove all pipe scale, rust, and foreign material. This is important to ensure a tight seal.
Step 2: Place the clamp around the pipe so that the leak is completely covered by the clamp gasket.
Step 3: Tighten the bolts evenly to the recommended torque specified in the table provided in the manual. The torque values vary depending on the size of the clamp. Make sure to use a torque wrench to achieve the correct torque.
Step 4: After tightening the bolts, pressure test the complete installation for leaks. This is important to ensure that the repair is effective.
Step 5: Check for leaks before leaving the repair site. If there are any leaks, you may need to re-tighten the bolts or make adjustments to ensure a proper seal.
It is important to note that the gasket material used in the clamp is Buna-N (Nitrile Rubber), which has temperature and pressure ratings specified in the manual. It is crucial not to exceed these ratings to prevent damage to the clamp and ensure its effectiveness.
If you have any further questions or concerns, please refer to the Skinner EM Emergency Pipe Repair Clamp Instruction Manual or contact the Skinner Company directly for assistance.
Add New Comment