User Manual Q&AAnswer
Feb 26, 2025 - 04:43 AM
To configure the easee EC001-BLACK Charge Intelligent Charging Station, follow these steps:
1. Turn on the power and make sure the charger is properly connected to the electrical supply.
2. Activate the WiFi of the Charging Robot by holding the touch button for 5 seconds. The light strip will light up green, indicating that the charger is sharing its local WiFi network.
3. On your smartphone, go to the WiFi settings and select the WiFi network of the Charging Robot. The network name starts with "Easee...". If you are unable to connect, try using flight mode.
4. Open the browser on your smartphone and enter "192.168.4.1" in the address bar.
5. Log in using the four-digit PIN code located on the front of the Chargeberry or on the back cover of the manual. You can also retrieve the PIN code from the Easee app.
6. Enter the installation details and follow the on-screen instructions. Make sure to specify the maximum charging current and fuse values as required by an authorized electrician.
7. After 15 minutes of commissioning, the values cannot be changed anymore via the WiFi interface. If you need to repeat the configuration, turn off and on the power supply to the charger.
8. If you have multiple backplates connected to the same fuse/cable, make sure to program all the backplates with the same Chargeberry for load balancing to work.
9. Once the configuration is complete, close the front cover of the Charging Robot and secure it with the locking xxxx at the bottom.
Your easee EC001-BLACK Charge Intelligent Charging Station is now configured and ready for use. For more information and troubleshooting, refer to the product manual.
Add New Comment