User Manual Q&AAnswer
Feb 26, 2025 - 04:42 AM
To install the ITT Conoflow GH40 Series Vacuum Service Regulator, follow these steps:
1. Ensure that the maximum supply pressure does not exceed 200 PSI (1379 kPa) for standard models or 300 PSI (2068 kPa) for stainless steel models.
2. The regulator has two 1/4" NPT connections. The inlet connection is marked "IN". It is recommended to use a filtered air supply.
3. After installation, check all connections for leakage.
4. Keep the adjusting xxxx well lubricated with grease.
For more detailed information and illustrations, please refer to the installation section in the ITT Conoflow GH40 Series Vacuum Service Regulators Instruction Manual.
Note: It is important to follow the installation instructions provided in the manual to ensure proper functioning and avoid any potential damage or safety hazards.
Add New Comment