User Manual Q&AAnswer
Feb 26, 2025 - 04:30 AM
To install the somogyi FLL 50 LED Spotlight, follow these steps:
1. Before installing and connecting the luminaire, make sure to disconnect the power supply.
2. Use screws and dowels to mount the luminaire on a wall with a suitable load-bearing capacity. The luminaire should be mounted at least 1.8 meters above the floor and up to 5 meters high.
3. Choose a location that provides IP65 protection for the floodlight.
4. Remove the cover of the junction box by removing the 4 screws.
5. Unscrew the outer plastic nut from the cable gland.
6. Thread the plastic nut onto the wire and feed the wire through the gland into the junction box.
7. Connect the power cables according to the terminal block markings.
8. xxxx the plastic nut tightly back onto the gland.
9. xxxx the gland cover back on, ensuring that the silicone gasket is in place. Tighten the 4 screws.
10. Adjust the angle of the floodlight as desired.
11. Finally, reconnect the circuit by switching on the circuit breaker.
Please note that the commissioning of the luminaire must be carried out by a specialist in compliance with the applicable safety and contact protection regulations.
Add New Comment