User Manual Q&AAnswer
Feb 26, 2025 - 03:56 AM
Installation:
1. Before starting the installation, make sure to disconnect the power to the product.
2. The Field Adjustable Module (FAM) is a factory-installed voltage regulating device that needs to be connected to the gray (-) and violet (+) 0-10V dimming leads of the LED driver.
3. Once connected, the FAM can be manually adjusted to dim the fixture in the field.
Adjustment:
1. The FAM has a switch with positions ranging from 1 to 10. Position 10 is the factory default and represents full brightness, while position 1 is the lowest brightness level.
2. To adjust the light output, rotate the actuator xxxx by hand or with a flat head screwdriver according to the provided table.
3. The table shows the corresponding dimming voltage and percentage of output power for each position.
4. The fixture's lumen output is approximately equal to the percentage of output power. You can calculate the actual lumens by multiplying the rated lumens by the percentage of output power.
5. For example, if the rated lumens are 15,000 lm and the FAM is set to position 7 with a 71% output power, the actual lumens would be 10,650 lm.
Note: The FAM is not compatible with DALI control or GE Light Grid. Also, please be aware that specifications are subject to change without notice, and actual performance may vary depending on application conditions.
For more information and updates, you can visit the GE Current website at gecurrent.com/evolve.
Add New Comment