How do I install the WATERWARE FWCU08 Cube Wall Mounted Bath Spout in Brushed Nickel? (WATERWARE FWCU08 Cube Wall Mounted Brushed Nickel Installation Guide)

Answer

manuals.plus

Feb 26, 2025 - 03:53 AM


To install the WATERWARE FWCU08 Cube Wall Mounted Bath Spout in Brushed Nickel, please follow these steps:

1. Position the Angle Elbow:  xxxx  the Angle Elbow in place using the provided screws. Connect the inlet water supply to the G1/2" male connector.

2. Test and Check for leaks: Ensure there are no leaks by turning on the water supply and checking for any water leakage.

3. Drill a hole: Drill a 30mm diameter hole through the tiles and lining where you want to install the bath spout.

4. Apply Teflon tape: Apply Teflon tape onto the spout adapter.  xxxx  the spout adapter into the female thread connector.

5. Fit the dress plate: Fit the dress plate onto the spout adapter. Tighten the positioning  xxxx  onto the spout. Push the spout assembly onto the spout adapter, ensuring the positioning hole aligns. Fasten the grub  xxxx  to secure the spout.

6. Finished work: Your installation is complete. Note that the spout must work together with a wall mixer.

Please refer to the provided installation guide for any additional details or illustrations specific to your product. It is important to comply with Australia standard AS/NZS3500 or relevant local authority requirements during installation.

Note: It is recommended to flush out all pipes prior to installation and to clean the product regularly using mild detergent or soapy water with a soft cloth or dampened sponge. Avoid using chemical or abrasive cleaners.