Answer

Feb 26, 2025 - 03:50 AM
To install the WATERWARE FWCU8268 Cube Tall Basin and Vessel Mixer, please follow the steps below:
1. Cut a 35mm hole in diameter and ensure there is a 60mm circle space for mounting.
2. Underneath the mounting hole, xxxx down the lock nut until the end of the mixer tail. Then, feed the metal washer followed by the rubber washer from the upside onto the mixer tail.
3. Feed the hoses through the mixer tail and then both the mixer tail and hoses through the hole.
4. Feed the dress ring onto the mixer tail and xxxx the hoses into the mixer body as per the provided instructions. While screwing, be careful not to scratch the dress ring. Place the mixer into position.
5. Underneath the mounting hole, firmly fasten the locknut and then tighten the screws.
6. Connect the hoses to the water supply. Test and check for leaks.
7. Once the installation is complete, your work is finished.
Please note the following important information:
- Pressure rating: The recommended pressure range is 150-500kpa. If the pressure exceeds or is likely to exceed 550kpa, an approved pressure limiting device must be installed.
- Temperature rating: The mixer is suitable for water temperatures up to 75°C. If the water temperature exceeds 55°C, an approved tempering valve must be fitted.
- Prior to installation, it is recommended to flush out all pipes.
- The installation should comply with Australia standard AS/NZS3500 or relevant local authority requirements.
For maintenance and care:
- Clean the product with a mild detergent or soapy water using a soft cloth or dampened sponge.
- After each use, dry the product with a soft cloth and clean it regularly.
- Avoid using any chemical or abrasive cleaners, as they may damage the product.
Please refer to the provided installation guide for more detailed instructions and illustrations.
Add New Comment