User Manual Q&AAnswer
Feb 26, 2025 - 03:21 AM
To adjust the output voltage and current limit of the power supply, follow these steps:
1. Locate the multi-turn potentiometers on the front panel of the power supply.
2. Use a screwdriver or similar tool to turn the potentiometers.
3. For adjusting the output voltage, turn the voltage potentiometer. The voltage can be adjusted from zero to the maximum value.
4. For adjusting the output current limit, turn the current potentiometer. The current can be adjusted from zero to the maximum value.
5. The power supply includes 16 pre-programmed output voltages that are set by the code switch. Refer to the setting table in the manual for this unit.
6. Any of these 16 different voltage settings can be taken into use and additionally be adjusted within ±5% using the trimmer on the front panel.
Note: The maximum output power of the power supply is available within the adjustment range. Make sure to refer to the manual for specific instructions on choosing the programmed voltage and fine-tuning the adjustment.
Please refer to the MICROPOWER GROUP PAP800UL Switched Mode Power Supply User Manual for more detailed instructions and illustrations.
Add New Comment