User Manual Q&AAnswer
Feb 26, 2025 - 03:03 AM
To activate the User Programming Mode on the GECI RED Diamond Charger, follow these steps:
1. Disconnect the battery from the charger.
2. Press and hold the DOWN button on the charger for 3 seconds.
3. The display will show the message "Enter the Programming Password."
4. Enter the programming password using the UP/DOWN buttons and press ENTER.
5. The charger will enter the User Programming Mode, and you can now modify the settings.
To modify a value in the User Programming Mode, follow these steps:
1. Scroll between the programmable values using the UP/DOWN buttons.
2. To modify a value, press ENTER and hold it for 2 seconds until the cursor starts blinking over the value that can be modified.
3. Use the UP/DOWN buttons to change the value.
4. Confirm the modified value by pressing ENTER for 2 seconds until the cursor disappears. The new value will be saved.
Remember to disconnect the battery before entering the User Programming Mode, and only expert users should modify the settings of the charger.
Add New Comment