Answer

Feb 26, 2025 - 02:55 AM
To clean or replace the filters, follow these steps:
1. Switch off the device by removing the plug from the socket.
2. Turn the two locking hooks located at the bottom or on the side of the housing.
3. Lift the cover of the Sensa by lifting it upwards.
4. For air supply filters, open the three clips on the left side and tilt the filter housing forwards.
5. Replace the two dirty air supply filters through the top and bottom of the filter housing.
6. Close the filter housing and secure it with the three clips. Make sure the filters do not protrude out of the housing.
7. If the filters do not need to be replaced, you can use a vacuum cleaner to clean them without opening the filter housing.
8. To replace the air outlet filters, unlock the filter housing by gently pulling the two clips towards you. Turn the filter grille as far forward as possible and push the filters out from the front of the housing.
9. Insert three new filters into the sections and press the grille at the bottom with the two clips firmly closed until it snaps. Ensure the filter housing is properly closed for proper operation.
10. To clean the air ducts, remove the two inspection hatches by turning them to the left and removing them.
11. Remove the round cups from the air duct and clean the dust and dirt from the insect mesh.
12. Use a vacuum cleaner or a soft cloth (do not use water) to remove any dirt from both channels.
13. Insert the round cups back into the air ducts. Install both inspection hatches and tighten them well.
14. Put the cover back on and turn the locking hooks (at the bottom or on the side of the housing).
15. Plug the device back into the socket.
16. If you have replaced the filters, reset the filter hour counter by simultaneously pressing the + and - buttons on the display for 6 seconds. The 'Filter vervuild' message will disappear.
Please note that it is important to reset the filter hour counter only if you have replaced the filters.
For further assistance or inquiries, you can contact ClimaRad at info@climarad.com or visit their website at www.climarad.co.uk. You can also reach them by phone at +31 541 358130.
Add New Comment