User Manual Q&AAnswer
Feb 26, 2025 - 02:48 AM
To set the synchronization parameters for the HSM340 Synchronous Module, you can use the PC test software provided by SmartGen. Here are the steps:
1. Connect the LINK port of the SG72 module (USB to LINK) to your computer.
2. Launch the PC test software.
3. In the software, navigate to the parameter settings section.
4. Locate the configurable parameters for the gens and bus systems.
5. Set the desired values for over voltage, under voltage, over frequency, and under frequency thresholds for both the gens and bus systems.
6. Save the settings.
By adjusting these parameters, you can customize the synchronization conditions for the module. Please refer to the user manual for more detailed instructions on using the PC test software and configuring the parameters.
Add New Comment