User Manual Q&AAnswer
Feb 26, 2025 - 02:14 AM
To load the HILTI DX 76 Powder actuated direct fastening tool, follow these steps:
1. Push the fastener into the fastener guide from the front until the washer of the fastener is held in place in the fastener guide.
2. Push a cartridge strip, narrow end first, into the cartridge barrel. Make sure the cartridge strip is fully recessed in the cartridge barrel.
3. Cycle the fastening tool with the cycling grip. This will load the fastening tool and make it ready for use.
It is important to always unload the fastening tool (remove cartridges and fasteners) whenever you interrupt work with the tool. Before all maintenance, cleaning, and setup activities, make sure there are no cartridges and no fasteners in the tool.
For more detailed instructions and safety information, please refer to the HILTI DX 76 Powder actuated direct fastening tool Instruction Manual.
Add New Comment