User Manual Q&AAnswer
Feb 26, 2025 - 02:04 AM
To set the work mode for the eyevision DT-RLC Two Wire Video Intercom System Accessories, follow these steps:
1. Make sure the unit is powered on.
2. Locate the DIP switches on the back of the unit.
3. By default, the unit is set to lock control mode.
4. To switch to light control mode, strike the DIP1 switch four times. The IN-USE indicator will flash once.
5. To switch back to lock control mode, strike the DIP1 switch four times again. The IN-USE indicator will flash twice.
6. After setting the work mode, the unit will automatically restart.
7. Note that the setting state is valid within 5 seconds. If there is no operation for more than five seconds, the unit will exit the setting mode automatically.
Please refer to the user manual for more detailed information and illustrations on setting the work mode for the eyevision DT-RLC Two Wire Video Intercom System Accessories.
Add New Comment