User Manual Q&AAnswer
Feb 26, 2025 - 01:32 AM
To install the Fanvil i61 Video Door Phone, follow these steps:
1. Drilling: Place the mounting template on the wall and drill the four holes marked on the template using an electric drill. It is recommended to drill about 50mm deep. Remove the template after drilling and push or hammer xxxx anchors into the holes.
2. Removing hanging bracket and back shell: Detach the wall bracket downward from the device and loosen the four screws on the rear cover using a screwdriver.
3. Install the wall bracket, wiring, and casing: Align the xxxx holes of the wall bracket with the holes in the wall and fix them using TA4*30mm screws. Pass all the wires through the silicone plug in the middle of the bottom case, ensuring that the outlet hole of the bottom case faces down. Connect the cables of RJ45, power, and electric-lock to the motherboard socket as mentioned in the connectors description. Connect the terminal of the wired cable to the motherboard socket.
4. Test electricity: Press the # button for 3 seconds to get the IP address of the intercom by voice. Input the access password or press the indoor switch to check the electric-lock installation. Do not proceed with mounting until you have finished the electric checking.
5. Attach the device to the wall bracket: Attach the device to the wall bracket in a top-down manner, locking the screws at the bottom.
For more detailed instructions and illustrations, please refer to the Fanvil i61 Video Door Phone Installation Guide provided with the product.
Add New Comment