Answer

Feb 26, 2025 - 12:56 AM
To assemble and operate the HEATSTAR HSVFRD10NG Infrared Vent-Free Radiant Natural Gas Space Heater, please follow the instructions provided in the owner's manual. Here is a step-by-step guide:
1. Safety Precautions: Before assembling or operating the heater, read and understand all safety instructions in the manual. Ensure that the heater is placed in a well-ventilated area and away from flammable materials.
2. Installation: Follow the installation instructions provided in the manual to properly connect the heater to the natural gas supply. It is recommended to have a qualified service agency install the heater to ensure proper installation and safety.
3. Lighting the Heater: Make sure the gas supply is turned off before attempting to light the heater. Follow the lighting instructions provided in the manual, which typically involve turning the gas control xxxx to the "Off" position, waiting for a few minutes, and then turning the xxxx to the "Pilot" position. Use a long-reach lighter or match to ignite the pilot flame. Once the pilot flame is lit, hold the xxxx in the "Pilot" position for about 30 seconds to allow the thermocouple to heat up. Release the xxxx and the pilot flame should remain lit.
4. Operating the Heater: After the pilot flame is lit, you can turn the gas control xxxx to the desired heat setting. The manual should provide information on how to adjust the heat output. Some models may have a thermostat control for maintaining a specific temperature.
5. Shutting Down the Heater: To turn off the heater, simply turn the gas control xxxx to the "Off" position. It is important to ensure that the pilot flame is completely extinguished.
Please note that the above instructions are a general guideline, and it is crucial to refer to the specific instructions provided in the HEATSTAR HSVFRD10NG Infrared Vent-Free Radiant Natural Gas Space Heater owner's manual for accurate and detailed information.
Add New Comment