How do I switch on and use the CONDTROL Fliesen 3D Laser Cross Line Laser? (CONDTROL Fliesen 3D Laser Cross Line Laser User Manual)

Answer

manuals.plus

Feb 26, 2025 - 12:05 AM

To switch on and use the CONDTROL Fliesen 3D Laser Cross Line Laser, follow these steps:

1. Power supply: The laser level is powered by a 3.7V 3000 mAh Li-ion rechargeable battery included in the delivery package. Install the battery in the battery compartment, observing the polarity.

2. Automatic leveling mode:
- Move the switch bar to the ON position.
- The laser level will switch on, and the LED indicator will turn green.
- The upper H-line will be on.
- Short press the switch bar to switch on the required laser lines.
- Short press the switch bar again to switch on/off the pulse mode. When the pulse mode is on, the LED indicator will be green.
- Move the switch bar to the OFF position to switch off the laser level.
- When the battery is low, the LED indicator will flash red.

3. Inclined lines mode:
- The switch bar should be in the OFF position.
- Press and hold the switch bar for 3 seconds to switch on the laser.
- The upper H-line will be on, and the laser line will flash every 5 seconds. The LED indicator will be red.
- Long press the switch bar for 3 seconds to switch on the required laser lines.
- After all combinations of lines are switched on, the next long press will switch off the laser level.
- Press and hold the switch bar for 3 seconds to switch on/off the pulse mode. When the pulse mode is on, the LED indicator will be green.

Note: It is recommended to switch on the laser only before starting the operation to increase the operating time and avoid unintentional blinding. The laser line may tremble due to the heterogeneity of the atmosphere and may vary in width depending on the operating distance. For maximum accuracy, use the middle portion of the laser line.

Please refer to the user manual for more detailed instructions and safety precautions.