User Manual Q&AAnswer
Feb 25, 2025 - 11:19 PM
To assemble the vita Kensington Planter Box and Trellis, follow these steps:
1. Lay out the front wall panel on a work surface.
2. Insert the side walls into the routed holes on the front wall panel posts. Push them until the panels bottom out. Fasten each panel with two 2 1/2" (64 mm) screws on the side of the trellis post.
3. Fit the front wall panel over the side walls. Push until the panels bottom out. Secure the side wall panels into the front wall panel with two 1 1/2” (38 mm) screws at the end of the rails. Make sure to only drill the screws halfway to prevent the panels from pulling out of the posts under stress.
4. Slide the floorboards together and place them inside the planter box.
5. Install the four post caps onto the four posts.
For a visual representation and additional information, please refer to the vita Kensington Planter Box and Trellis Instruction Manual provided with the product. If you have any missing or defective parts, please contact the customer service department at 1-800-282-9346 (Mon. to Fri. 8:00 AM to 5:00 PM EST).
Add New Comment