User Manual Q&AAnswer
Feb 25, 2025 - 11:06 PM
To calibrate the meter on the Lindell Audio LiN76 Vintage Limiting Amplifier, follow these steps:
1. Set the meter to GR (gain reduction) mode.
2. Make sure that no ratios are selected by pressing in any ratio button just enough that all four pop out.
3. Locate the meter calibration set xxxx on the back of the unit.
4. Using a flathead screwdriver, rotate the xxxx on the rear panel until the needle rests on 0.
By following these steps, you can calibrate the meter to ensure that it returns to zero when no compression is being applied. For more information, refer to the "Meter Calibration" section in the instruction manual.
Add New Comment