User Manual Q&AAnswer
Feb 25, 2025 - 09:37 PM
To switch between wet and dry suction modes on the GLOBAL INDUSTRIAL 713166 HEPA Wet Dry Vacuum, follow these steps:
1. For WET suction use:
a. Remove the motor head from the vacuum's body by opening the side hasps and lifting using the handle.
b. Check to ensure the float valve can travel up and down freely and is not restricted.
c. Remove the HEPA filter and filter bag.
d. Install the rubber seal in between the tank body and motor head assembly.
e. Reinstall the motor head back onto the vacuum's body and secure it into place using the side hasps.
2. For DRY suction use:
a. Remove the motor head from the vacuum's body by opening the side hasps and lifting using the handle.
b. Ensure the filter bag and HEPA filter are fitted correctly, clean, and not damaged.
c. Reinstall the motor head back onto the vacuum's body and secure it into place using the side hasps.
Warning: Do not use this machine for wet suction while the filter dust bag and HEPA filter are in place. Debris will come in contact with the motor directly and can cause damage. Make sure the tank contains no water when it is used for dust suction.
Please refer to the user manual for more detailed instructions and safety precautions.
Add New Comment