User Manual Q&AAnswer
Feb 25, 2025 - 09:16 PM
To connect the eDIDIO S10 controller to your network, you will need to use an Ethernet cable. Follow these steps:
1. Ensure that you have a router with DHCP capabilities.
2. Connect one end of the Ethernet cable to the Ethernet port on the eDIDIO S10 controller.
3. Connect the other end of the Ethernet cable to an available Ethernet port on your router.
4. Power on the eDIDIO S10 controller using a suitable 24VDC power supply.
5. Wait for the controller to boot up and establish a network connection. You can check the network status on the OLED display of the controller.
6. Once the network connection is established, you can use the Configurator V2 application to configure and control the eDIDIO S10 controller.
For more detailed instructions and troubleshooting tips, please refer to the "Ethernet Connectivity" section of the user manual.
Add New Comment