How should I install the Danfoss SVL Housings Brazed Versions? (Danfoss SVL Housings Brazed Versions Installation Guide)

Answer

manuals.plus

Feb 25, 2025 - 08:28 PM

To install the Danfoss SVL Housings Brazed Versions, follow these steps:

1. Determine the possible orientations: The housing can be installed in various orientations, but it is recommended to have a flow direction of 100%. However, if necessary, the flow can be reduced to 90-100%.

2. Prepare for installation: Before starting the installation, ensure that the Ag40 temperature is within the range of 450-700 °C. Remove the top cover/insert and clean the connections with a suitable cleaning agent.

3. Wrap around wet cloth: Wrap a wet cloth around the piping ends to protect them from excessive heat during the brazing process.

4. Apply flux on piping ends: Apply flux on the ends of the piping to facilitate the brazing process.

5. Apply inert gas internally: Apply an inert gas internally to prevent oxidation and ensure a clean brazing process.

6. Heat up piping: Heat up the piping using a suitable heat source until it reaches the required temperature for brazing.

7. Brazing: Use the recommended brazing material and ensure that the brazing is done within the specified temperature range. Follow the brazing instructions provided in the manual.

8. Remove residual flux: After brazing, make sure to remove any residual flux from the connections to prevent any potential issues.

Please note that the above instructions are a general guide. For specific installation details and safety precautions, refer to the Danfoss SVL Housings Brazed Versions Installation Guide provided by the manufacturer.