User Manual Q&AAnswer
Feb 25, 2025 - 07:46 AM
Sure! Here is a step-by-step guide on how to install the EMTEK 2184 Square Passage Pocket Door Mortise Lock:
1. Start by ensuring that the Drive Bar Socket is in the 12 o'clock position, as shown in the installation guide. This is important for proper functioning of the lock.
2. xxxx the Thread Drive Bar Cylinder into the lock body, making sure that the notches on the cylinder are parallel with the horizontal plane when fully screwed in.
3. Install the lock body into the door according to the specifications provided in the template for door prep. This will involve cutting out a recess in the door to accommodate the lock body.
4. Install the Inside and Outside Plates on the door. The Inside Plate should be installed on the side of the door where the lock will be operated from the inside, while the Outside Plate should be installed on the side where the lock will be operated from the outside.
5. Tighten the Key Cylinder by tightening the locking xxxx to engage the notches on the cylinder. This will secure the cylinder in place.
6. Install the Trim Plate, which is the decorative plate that covers the lock mechanism on the door.
7. Prepare the door jamb according to the specifications provided in the template. This may involve cutting out a recess in the door jamb to accommodate the lock strike plate.
8. Install the Lock Body into the door jamb, aligning it with the lock on the door.
9. Install the Outside Plate on the door jamb, ensuring that it aligns with the lock body.
10. Install the Inside Plate on the door jamb, aligning it with the lock body.
11. Finally, install the Trim Plate on the door jamb to cover the lock mechanism.
Remember to refer to the installation guide and template provided with the lock for specific measurements and details. If you have any further questions or need additional assistance, please consult the manual or contact EMTEK customer support.
Add New Comment