User Manual Q&AAnswer
Feb 25, 2025 - 07:41 AM
To install the ANOLiS Eminere Inground 2, 4 Wireless DMX, follow these steps:
1. Prepare a hole with good drainage and at least 300mm of gravel at the bottom.
2. Remove the temporary cover from the mounting sleeve by unscrewing the cap head allen bolts.
3. If installing multiple fixtures side by side, use the four holes on the side of the mounting sleeve to attach the next mounting sleeve using screws and rubber grommets.
4. Ground the Eminere Inground and the mounting sleeves by connecting the grounding points.
5. Connect the Eminere Inground and all necessary cables to the junction box. Use a protective tube for the supply cable and power/data cable.
6. xxxx the Eminere Inground to the mounting sleeve using countersunk allen head bolts. Tighten the screws smoothly with a torque of 4Nm.
7. xxxx the cover plates on the mounting sleeve using countersunk allen head bolts. Tighten the screws smoothly with a torque of 4Nm.
8. If installing multiple fixtures side by side, use the end, middle, and continuous cover plates between the mounting sleeves.
9. Adjust the tilt of the Eminere Inground by pushing and holding the small tube to release the lock, then tilt the device to the desired position. Release the small tube to lock the new position.
10. Address the DMX of the connected Eminere Ingrounds manually using the Robe Universal Interface WTX and the software RDM Manager.
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment