User Manual Q&AAnswer
Feb 25, 2025 - 07:23 AM
To select and monitor an audio pair using the Wohler AMP1-2SDA AES3 and Analog Audio Monitor, follow these steps:
1. Power on the monitor and ensure it is connected to the audio source (3G/HD/SD-SDI, AES3, or Analog).
2. On the front panel of the monitor, you will find two rotary controls. The first control allows you to select the source type (SDI, AES3, or Analog). Rotate this control to the desired source type.
3. Once you have selected the source type, use the second rotary control to move through the corresponding audio pairs. Rotate this control to select the desired audio pair.
4. The selected source and audio pair will be displayed on the large front panel screen. This display is highly visible, even in busy technical environments.
5. Adjust the volume and balance controls as needed to achieve the desired audio levels and balance between the left and right channels.
6. The monitor also features two 26-segment LED meters that display the levels of the selected audio pair. Use these meters to monitor the audio levels.
7. If required, you can make further adjustments using the tone controls for adjusting the audio output and the audio trim control for altering the analog output levels.
8. The AMP1-2SDA provides multiple monitoring options. You can monitor through the built-in speakers, headphones, or analog outputs, depending on your preference.
Please refer to the Wohler AMP1-2SDA AES3 and Analog Audio Monitor Owner's Manual for more detailed instructions and information on the various features and functions of the monitor.
Add New Comment