How do I install the BEALE STREET AUDIO IW5-BSC 5.25 Inch In Wall Speaker? (BEALE STREET AUDIO W5-BSC in Wall Speaker Installation Guide)

Answer

manuals.plus

Feb 25, 2025 - 07:09 AM

To install the BEALE STREET AUDIO IW5-BSC 5.25 Inch In Wall Speaker, please follow these steps:

1. Use a stud finder to locate an area on the wall that is free of obstructions or studs.
2. Position the provided cutout template on the wall where you want to install the speaker. Trace the template to mark out the speaker location.
3. Drill a pilot hole and cut along the traced outline to create the speaker hole.
4. Pull the speaker wire out of the hole and connect it to the speaker. Ensure proper polarity by connecting the Left/- of the amp terminals to the Left/- on the speaker, and the Right/+ on the amp to the Right/+ terminals on the speaker.
5. Place the speaker into the wall and tighten all of the dog ear screws using a Phillips screwdriver to secure it in place.
6. Attach the grille to the speaker.
7. Connect the other end of the speaker wire to the amplifier.
8. Repeat the above steps for any additional speakers.

For more detailed instructions and illustrations, please refer to the BEALE STREET AUDIO IW5-BSC 5.25 Inch In Wall Speaker Installation Guide provided with your purchase.

Note: If you plan to paint the grille, remove it from the speaker before painting. Be cautious not to clog the fine holes within the grille with excessive paint. Also, remove the cloth on the backside of the grille before painting to prevent it from absorbing the paint and affecting the sound quality.

If you encounter any issues or have further questions, please refer to the troubleshooting section in the manual or contact the Vanco authorized distributor/dealer from whom you purchased the speaker for assistance.