User Manual Q&AAnswer
Feb 25, 2025 - 06:47 AM
To adjust the fit of the helmet, follow these steps:
1. Rotate the xxxx on the back of the headband to make the overall circumference of the headband larger or smaller. This can be done while wearing the helmet to achieve the right tension without it being too tight.
2. If the headband is riding too high or too low on your head, adjust the strap that passes over the top of your head. Release the end of the band by pushing the locking pin out of the hole in the band. Slide the two portions of the band to a greater or lesser width as required and push the locking pin through the nearest hole.
3. Test the fit of the headband by lifting up and closing down the helmet a few times while wearing it. If the headband moves while tilting, re-adjust it until it is stable.
For more information and illustrations, please refer to the "Adjusting The Fit Of The Helmet" section in the Magmaweld MKM 620MA Auto Darkening Welding Helmet User Manual.
Add New Comment