How do I mount the InfiRay CD35 NV Digital Night Vision Scope on my day device? (InfiRay CD35 NV Digital Night Vision Scope User Guide)

Answer

manuals.plus

Feb 25, 2025 - 05:21 AM

To mount the InfiRay CD35 NV Digital Night Vision Scope on your day device, follow these steps:

1. Make sure that your day device is zeroed before installation.
2. Select the appropriate adapter with an insert of the required diameter based on the outer diameter of the objective lens of your day device.
3. Measure the outer diameter of the housing of the lens of your day device and choose the corresponding insert.
4. Install the insert into the adapter all the way in.
5. Firmly install the adapter with the insert onto the objective lens of your day device.
6. Snap the lever from the original OPEN position to the CLOSE position. Ensure that the adapter fits tightly on the objective lens.
7. If there is a clearance, loosen the locking xxxx with the provided hex-nut wrench (S=2mm).
8. Tighten the xxxx with the hex-nut wrench (S=4mm) to ensure a tight fit of the adapter on the objective lens.
9. Tighten the locking xxxx .
10. Rotate the Clip into the adapter to the appropriate position and tighten the bayonet ring counterclockwise to lock the Clip.

Note: It is recommended to decrease the objective lens of your day device and the inner side of the insert before installing the cover adapter. Do not move the observed target and position of the day device during installation to facilitate alignment of the optical axis of the Clip.

For more detailed instructions and illustrations, please refer to the "Mounting On The Day Device" section in the InfiRay CD35 NV Digital Night Vision Scope User Guide.