User Manual Q&AAnswer
Feb 25, 2025 - 04:51 AM
To remove and install the Evaporative Emission Canister Purge Valve on a 2008 Ford Focus, please follow the steps below:
Removal:
1. Ensure that there are no open flames or sources of ignition nearby, as fuel vapors may be present.
2. Disconnect the quick release couplings. Refer to the Quick Release Coupling section in the manual for more details.
3. Loosen the clamp and position aside the air cleaner outlet pipe. Torque the clamp to 42 lb.in (4.8 Nm).
4. Disconnect the electrical connector.
5. Disconnect the quick release coupling. Refer to the Quick Release Coupling section in the manual for more details.
6. Remove the fastener securing the purge valve. Torque the fastener to 97 lb.in (11 Nm).
Installation:
1. To install the new purge valve, reverse the removal procedure.
2. Ensure that all connections are securely fastened and properly aligned.
3. Tighten the fastener securing the purge valve to 97 lb.in (11 Nm).
4. Connect the quick release couplings as per the Quick Release Coupling section in the manual.
5. Reconnect the electrical connector.
6. Position the air cleaner outlet pipe back in place and tighten the clamp to 42 lb.in (4.8 Nm).
Please note that these instructions are a general guide and may vary slightly depending on the specific vehicle model and configuration. It is always recommended to consult the vehicle's service manual or seek professional assistance for accurate and safe installation.
Add New Comment