User Manual Q&AAnswer
Feb 25, 2025 - 04:36 AM
To program the remote control, follow these steps:
1. For a standard key start vehicle:
- Turn the vehicle's key between the Ignition on and off (or the Acc & On positions) five times within 10 seconds. The parking lights will flash once to indicate successful activation of programming mode.
- Within 10 seconds, tap the Lock button on the remote (a quick 0.5 second press and release). The parking lights will flash once to confirm the remote has been coded. Repeat this step for each additional remote, up to 4.
2. For a Push to Start (PTS) vehicle:
- Set the vehicle to the ignition or "ON" position.
- Within 5 seconds, push to the "OFF" position.
- Within 5 seconds, set the vehicle to the ignition or "ON" position (do not start).
- Within 5 seconds, depress and release the foot brake 3 times. The parking lights will flash once to indicate remote programming is enabled.
- Tap the Lock button on the remote (a quick 0.5 second press and release). The parking lights will flash once to indicate the remote code has been accepted. Repeat this step for each additional remote, up to 4.
Note: If no valid remotes are programmed, the control module (CM) will enter valet mode. The parking lights will flash twice to signal the end of programming mode.
For further assistance or if you have any other questions, please contact the original place of purchase or client services at 888-820-3690.
Add New Comment