User Manual Q&AAnswer
Feb 25, 2025 - 03:41 AM
To install the Philips DV001 EasyKey Smart Door Viewer, please follow these steps:
1. Confirm installation position: If there is no hole on the door, drill one with a diameter of 15-30mm at the height of 145cm from the ground. If there is a hole on the door with a peephole, remove the peephole and install the smart door viewer. The hole diameter range should be 15-50mm.
2. Choose the proper xxxx : Select the appropriate xxxx size based on the door thickness. Use short screws for a door thickness of 35mm-60mm, medium screws for 60mm-85mm, and long screws for 85mm-110mm.
3. Sub-unit pre-installation: Tighten the xxxx into the sub-unit for 5mm and remove the foam label protective sheet on the rear side of the sub-unit.
4. Fix sub-unit: Adjust the direction of the sub-unit from outside and make sure the doorbell button is at the bottom. Pass the xxxx and connecting cable through the hole. Press xxxx the sub-unit to ensure it adheres perfectly to the door, then remove the lens protective film.
5. Magnetic Stand Installation: Pass the connecting cable of the sub-unit through the square hole on the magnetic stand from the inside door. Move down the magnetic stand so that the screws can be matched with the marked position, and then fasten the screws. Hang the magnetic stand on the screws of the sub-unit and fasten them until the magnetic stand is firmly fixed on the door.
6. Fix sub-unit interface: Gently pull out the connecting cable from the inside door and peel off the protection film on the back of the sub-unit interface. Align the sub-unit interface with the groove on the magnetic stand and ensure they stick to each other firmly.
7. Host Installation: Tilt the host by 10 degrees and hang it on the steel sheet from top to bottom. The bottom magnet will automatically attach to the host. After installation, gently pull the upper part of the host to check if it is correctly installed.
For more detailed instructions and illustrations, please refer to the user manual provided with the product.
Add New Comment