User Manual Q&AAnswer
Feb 25, 2025 - 02:03 AM
To set the IC number and perform electronic cutting for the Paulmann 704.80 Digital LED Stripe Set, please follow the instructions provided in the manual.
1. IC Number Setting: The IC number setting allows you to synchronize multiple LED strips. Here's how to do it:
a. Start by connecting the LED strips together using the connectors provided.
b. Locate the IC number setting area on the LED strip. It is usually marked with an "IC" symbol.
c. Use a small screwdriver or similar tool to adjust the IC number. The IC number is a small dial or switch that can be turned or flipped.
d. Set the same IC number for all the LED strips you want to synchronize. This ensures that they will work together.
2. Electronic Cutting: The LED strip can be cut to the desired length. Here's how to perform electronic cutting:
a. Determine the desired cutting point on the LED strip. The cutting points are usually marked with scissor symbols.
b. Make sure the LED strip is disconnected from the power source before cutting.
c. Use sharp scissors or a cutting tool to cut along the marked cutting point. Be careful not to damage the LED components.
d. After cutting, you can use the remaining part of the LED strip or connect additional connectors to extend the length.
Please refer to the manual for any additional information or specific instructions related to the Paulmann 704.80 Digital LED Stripe Set. You can find the manual at www.paulmann.com/manual-digled/all.
Add New Comment