User Manual Q&AAnswer
Feb 25, 2025 - 01:52 AM
To connect the camera modules to the Thundercomm D660 TurboX Development Kit, follow these steps:
1. Take out the D660 Development Kit board from the package carefully.
2. Locate the camera connectors on the board:
- Camera connector 1 (connector 12): This is the default front camera connector.
- Camera connector 2 (connector 13): This is the default rear camera connector.
3. Connect the camera modules to the board using the appropriate camera connectors.
- For the front camera, connect it to Camera connector 1.
- For the rear camera, connect it to Camera connector 2.
4. Ensure that the camera modules are securely connected to the board.
5. You can now proceed with the rest of the setup and boot up the device.
Please refer to the Thundercomm D660 TurboX Development Kit User Guide for more detailed instructions and illustrations on connecting the camera modules.
Add New Comment