User Manual Q&AAnswer
Feb 25, 2025 - 01:06 AM
To install the CLDMPD6 6 Inches Slim Led Light Flood Beam and wiring harness, please follow the steps below:
1. Determine suitable mounting locations: Choose the desired locations to install the LED work lights, wiring harness, and switch. Ensure that the mounting locations are secure and will provide optimal lighting.
2. Mounting bracket installation: Use the included bottom mount brackets and mounting hardware to secure the LED work light in the chosen location. Adjust the light to the desired angle and tighten all mounting screws to secure it in place.
3. Harness installation: Please note that the wiring harness is sold separately. Once you have the harness, follow these steps:
a. Connect the wires: Connect the positive wire and negative wire of the LED work light to the corresponding wires of the wiring harness. Ensure proper insulation at the connections to prevent any electrical issues.
b. Test the lights: Press the switch on the wiring harness to test if the lights are functioning properly. If they do not turn on, double-check the connections and ensure they are secure.
4. Final adjustments: Once the lights are functioning properly, adjust the light to the desired angle if needed. Make sure to tighten all mounting screws to secure the light in its final position.
For further assistance or more detailed instructions, you can refer to the included instruction manual or visit the website CLDLED.COM.
Add New Comment