How do I install the HILTI X-BT-MF-N M10 Threaded Studs? (HILTI X-BT-MF-N M10 Threaded Studs Instruction Manual)

Answer

manuals.plus

Feb 25, 2025 - 12:40 AM

To install the HILTI X-BT-MF-N M10 Threaded Studs, please follow the installation instructions provided in the manual. Here is a step-by-step guide:

1. Preparation: Ensure that you have all the necessary tools and equipment for the installation, including a drill, a hammer, and appropriate safety gear.

2. Marking: Determine the desired location for the threaded stud and mark it on the surface. Ensure that the marking is accurate and aligned with the intended application.

3. Drilling: Use a drill with the appropriate size and type of drill bit to create a hole in the marked location. The diameter of the hole should match the size of the threaded stud (M10 in this case). Follow the drilling guidelines provided in the manual, including the recommended drilling depth.

4. Cleaning: Remove any debris or dust from the drilled hole using a brush or compressed air. This step is crucial to ensure proper adhesion and secure installation.

5. Insertion: Insert the HILTI X-BT-MF-N M10 Threaded Stud into the drilled hole. Use a hammer to gently tap the stud into place, ensuring that it is fully inserted and flush with the surface.

6. Tightening: If necessary, use a wrench or suitable tool to tighten the threaded stud further. Follow the recommended torque specifications provided in the manual to avoid over-tightening or damaging the stud.

7. Verification: After installation, visually inspect the threaded stud to ensure it is securely fastened and properly aligned. Verify that it meets the required specifications and is ready for use.

Please note that this answer is a general guide based on the information provided. For specific instructions and safety precautions, it is essential to refer to the HILTI X-BT-MF-N M10 Threaded Studs Instruction Manual.