User Manual Q&AAnswer
Feb 25, 2025 - 12:35 AM
To connect the ENDORFY EY6A008 LIX Wireless Ultralight Gaming Mouse to your desktop, please follow the steps below:
1. Ensure that your desktop is powered on and in a working condition before connecting the mouse.
2. Locate the USB receiver that came with the mouse. It is usually a small dongle that needs to be plugged into a USB port on your desktop.
3. Insert the USB receiver into an available USB port on your desktop. Make sure it is securely connected.
4. Turn on the mouse by pressing the power button, usually located on the bottom or side of the mouse. The mouse should start blinking or showing a light to indicate that it is in pairing mode.
5. Wait for your desktop to recognize the mouse. This may take a few seconds. Once recognized, the mouse should be ready to use.
If the mouse does not connect or is not recognized by your desktop, try the following troubleshooting steps:
- Ensure that the USB receiver is properly inserted into a working USB port.
- Make sure the mouse has fresh batteries installed, if it is battery-powered.
- Restart your desktop and try connecting the mouse again.
- Check if there are any conflicting software or drivers installed on your desktop that may be interfering with the mouse's connection.
- Refer to the user manual for any specific troubleshooting steps or contact Endorfy Technical Support for further assistance.
Please note that the information provided is based on the general instructions mentioned in the user manual. For detailed and specific instructions, it is recommended to refer to the user manual that came with the ENDORFY EY6A008 LIX Wireless Ultralight Gaming Mouse.
Add New Comment