User Manual Q&AAnswer
Feb 25, 2025 - 12:28 AM
To install the Bauer 58014 Wood Carving Disc on your angle grinder, follow these steps:
1. Make sure the power switch/trigger of the power tool is in the off-position and unplug the tool from its electrical outlet.
2. Press in and hold the grinder's spindle lock (if equipped) and use a spanner wrench to loosen and remove the grinder's outer flange nut.
3. Carefully remove the center plug holding the three components of the Carving Disc assembly together and retain it for future use.
4. Hold the Disc firmly so the components don't separate and with the side-stamped TOP facing up, place it over the grinder spindle until seated on the grinder's inner flange.
Note: If the components become separated, refer to the Disc and Chain Assembly section in the manual.
5. Thread the outer flange nut into place and tighten it securely with a spanner wrench.
Make sure to follow all safety precautions and instructions provided in the manual while installing and using the Wood Carving Disc.
Add New Comment