User Manual Q&AAnswer
Feb 25, 2025 - 12:21 AM
To install the Maiwe MIGE2206G-2GF-4GT Industrial Ethernet Switch, please follow these steps:
1. Wear anti-static gloves during the installation process and power off the switch.
2. Ensure that the input voltage is within the range marked on the switch.
3. Use a standard Cat5e/6 network cable for the best transmission distance.
4. Ground the equipment for lightning protection using a wire of No. 20 or more.
5. Lay out the power line, ground line, and signal line separately with a distance of at least 5cm.
6. Tilt the switch upwards and fasten the upper end of the buckle to the upper end of the DIN rail.
7. Buckle the lower end of the back buckle into the DIN rail.
8. Connect the optical fiber and network cables to the appropriate ports.
9. Make sure to install dust plugs on unused optical connectors and optical modules.
10. Ensure that the bending radius of the optical fiber is greater than 20 times the diameter of the fiber.
11. Connect the power cord to the power terminal according to the defined voltage input.
12. Power on the switch by plugging in the power cord.
13. To power off, unplug the power cord first and then remove it.
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment