How do I install the LUMENA LRPC240 Remote Photocell? (LUMENA LRPC240 Remote Photocell Installation Guide)

Answer

manuals.plus

Feb 25, 2025 - 12:00 AM

To install the LUMENA LRPC240 Remote Photocell, please follow these steps:

1. Select a suitable open mounting position where the photocell will not be affected by the light output of the fitting.
2. Make an 18-20mm diameter hole in the mounting surface, ensuring that the hole is free from burrs or rough edges.
3. Remove the nut of the external PC by unscrewing it anti-clockwise and lift off the top rubber washer.
4. Install the photocell in the prepared hole from the inside, making sure that the bottom rubber washer is in place internally, between the mounting surface and the photocell backing.
5. Fit the top rubber washer to the protruding photocell on the outside of the mounting surface and firmly secure it in place with the nut removed in step 3 by turning it clockwise.
6. Wire in the 240v power supply and the fitting to be powered by following the provided diagram.
7. Reconnect to the power supply, ensuring all connections are secure and no bare wires are left free of the terminals.
8. Restore the power and test the photocell by covering it to switch on the light. Wait for one minute, then remove the cover and check if the light has switched off.

Please note that it is important to mount the sensor in a location where it is not obstructed or affected by other lighting, especially the light it is controlling. Also, make sure to follow all safety precautions mentioned in the manual and consult a competent electrician if needed.

For more information and specific details, please refer to the LUMENA LRPC240 Remote Photocell Installation Guide provided with the product or visit the manufacturer's website at www.lumenalights.com.