User Manual Q&AAnswer
Feb 24, 2025 - 11:03 PM
To pair the Zigbee 100W LED Driver with your Zigbee network, follow these steps:
1. Make sure the device is not already added to a Zigbee network. If it is, remove it from the network by performing a factory reset. Refer to the "Factory Reset Manually" section in the instruction manual for detailed instructions.
2. From your Zigbee Controller or hub interface, choose to add a lighting device and enter Pairing mode as instructed by the controller.
3. Power on the Zigbee 100W LED Driver. It will enter network pairing mode, indicated by the connected light flashing twice slowly. The network pairing mode will remain active until the device is added to a Zigbee network.
4. The Zigbee 100W LED Driver should now be discoverable by your Zigbee Controller or hub. Follow the pairing instructions provided by your controller to complete the pairing process.
Note: If you want to pair the Zigbee 100W LED Driver with a Zigbee remote, you can use the Touchlink commissioning method. Refer to the "TouchLink to a Zigbee Remote" section in the instruction manual for detailed instructions.
It is recommended to refer to the instruction manual for any specific instructions or troubleshooting steps related to your Zigbee controller or hub
Add New Comment