User Manual Q&AAnswer
Feb 24, 2025 - 09:56 PM
To mount the Leonton PG5-1600-M12XB-110-67 Managed PoE Switch on a wall, follow these steps:
1. Prepare four screws for mounting the switch to a wall. It is recommended to use M5 screws.
2. Based on the physical dimensions shown in Figure 3.2 of the manual, mark the positions of the four xxxx holes on the left and right side of the switch on the wall.
3. Insert the screws through the xxxx holes on the switch and xxxx the switch into the wall.
4. To remove the switch from the wall, simply reverse the steps above.
Note: Make sure to disconnect all cables from the switch before removing it from the wall.
Please refer to the "Mounting Installation" section of the manual for more detailed instructions and illustrations.
Add New Comment