User Manual Q&AAnswer
Feb 24, 2025 - 09:45 PM
To install the Leonton EG5-1600-M12XB-110-67, EG5-1600-M12XB-110-T67 Gigabit Managed Ethernet switch, please follow these steps:
1. Unpack the switch from the original packing box.
2. Mount the switch on a wall using the xxxx holes provided. Use M5 screws for mounting.
3. Power on the switch by connecting the power inputs. The power LED will turn on.
- Use a UL Listed industrial use power supply.
- Connect the positive and negative power wires to the power connector on the switch.
- Tighten the xxxx nut to secure the connector.
4. Prepare the M12 cables for Ethernet connection.
5. Insert one side of the M12 cable into the switch's Ethernet port and the other side into the networking device's Ethernet port.
- The Ethernet port's LED on the switch will turn on when the cable is connected.
6. Once all connections are set and the LED lights show normal, the installation is complete.
Please refer to the "Mounting Installation" and "Hardware Installation" sections of the user manual for more detailed instructions and illustrations.
Note: If you encounter any issues during installation or need further assistance, please contact Leonton Technologies for technical support. Their contact information can be found at the end of the user manual.
Add New Comment