User Manual Q&AAnswer
Feb 24, 2025 - 09:16 PM
To install the Hard Head 023309 Separating Door, please follow these steps:
1. Fully unfold the plastic sheet provided with the product.
2. Place a strip of tape at the top of the plastic, with half the width of the strip outside the plastic. Tape the plastic over the door, ensuring that the bottom edge of the plastic reaches the floor.
3. To limit dust under the door, overlap with two to three sheets of plastic at the floor.
4. Stretch out the plastic and tape the sides in place.
5. Stick the zip firmly onto the plastic in the middle of the door opening, starting from below. The zip fastener should be at the top when the door is closed.
6. Open the zip and cut a hole in the plastic with a hobby knife between the two halves of the zip.
Please refer to Figure 1 in the instruction manual for a visual representation of the installation process.
Note: It is important to read the entire instruction manual provided by Jula AB for complete and accurate installation instructions.
Add New Comment