User Manual Q&AAnswer
Feb 24, 2025 - 09:05 PM
To connect your speakers to the DAYTON AUDIO KAB-100Mv2 amplifier board, you will need to use the Speaker Output Connector labeled J2 MOLEX-4PIN-3MM. The pin definitions for this connector are as follows:
- OUT+: This is the positive terminal for one channel of the speaker.
- OUT-: This is the negative terminal for one channel of the speaker.
- OUT+: This is the positive terminal for the other channel of the speaker.
- OUT-: This is the negative terminal for the other channel of the speaker.
To connect your speakers, you will need to match the positive and negative terminals of each channel to the corresponding terminals on your speakers. Ensure that the connections are secure and properly insulated to avoid any short circuits or damage to the amplifier or speakers.
Please refer to the user manual for further instructions and illustrations on how to connect your speakers to the amplifier board.
Add New Comment