User Manual Q&AAnswer
Feb 24, 2025 - 09:55 AM
To program the end positions for the elero RolTop-D+ M Roller Shutter Drive, you can follow the steps outlined in the manual. Here is a summary of the process:
1. Connect the electrical system according to the instructions in Chapter 5.2.
2. Check the operation and make any necessary adjustments to the directional controls of the operation switch.
3. To program the upper end position, press the UP arrow key and move the shutter to the upper stop. The drive will automatically switch off when it reaches the end stop.
4. To program the lower end position, press the DOWN arrow key until the shutter is shut down up to 30 cm. Repeat this step two more times.
5. Press the UP arrow key until the roller shutter is ascended about 30 cm. Repeat this step two more times.
6. The programming of the end positions is now completed.
It's important to note that the drive must be driven into the upper and lower end positions three times each, and the drive must stop automatically each time. This ensures that the end positions are accurately programmed.
For more detailed instructions and troubleshooting information, please refer to the elero RolTop-D+ M Roller Shutter Drive Instruction Manual.
Add New Comment