User Manual Q&AAnswer
Feb 24, 2025 - 07:43 AM
To set the end positions and turning range for the elero Ja comfort-868 Venetian Blind Drive, follow these steps:
1. Start by setting the upper end position. Press the OPEN button until the desired position is reached. Corrections can be made using the OPEN and DOWN/CLOSE buttons. If the DOWN/CLOSE button is pressed down permanently, this position will be stored. Press the DOWN/CLOSED button until the drive stops automatically. The upper end position has been freely configured.
2. If you want to set the upper end position to the cover position (with cyclical reference runs), press the OPEN button until the drive is stopped by the mushroom button. Press and hold down the OPEN button and the DOWN/CLOSE button until the desired position is reached. Let go of both buttons. The upper end position is set and is located at the position in front of the mushroom button. Cyclical reference runs are performed.
3. After setting the upper end position, you can set the turning range of the slats. This is the range of movement in which the position of the slats is set at low speed. The standard setting is 270° based on the drive shaft. This can be changed when setting the lower end position, with a minimum of 90° (first OPEN movement plus 1 increment) and a maximum of 360°.
Please refer to the elero Ja comfort-868 Venetian Blind Drive Instruction Manual for more detailed instructions and illustrations.
Add New Comment